Testing the LANZAR, 200W amplifier. Measurements, specifications
| Testing device | Amplifier LANZAR 200W |
| Sampling mode | 24-bit, 48 kHz |
| Interface | E-MU1616m |
| Testing chain | E-MU1616m>Amplifier LANZAR 200W>E-MU1616m |
| Constant voltage DC | -52V...0...+52V |
| Load resistance | 4 Ohm |
| Testing power | 150W |
| Maximum power | 230W |
| Output transistors | 2SA1943/2SC5200 TOSHIBA |
| Quiescent current | 250mA |
| 20 Hz - 20 kHz filter | ON |
| Normalize amplitude | ON |
| Level change | -0.2 dB / -0.2 dB |
| Mono mode | ON |
| Calibration singal, Hz | 1000 |
| Polarity | correct/correct |
Summary
| Frequency response (from 40 Hz to 15 kHz), dB | +0.02, -0.15 |
Very good |
| Noise level, dB (A) | -111.6 |
Excellent |
| Dynamic range, dB (A) | 111.6 |
Excellent |
| THD, % | 0.016 |
Good |
| THD + Noise, dB (A) | -73.5 |
Good |
| IMD + Noise, % | 0.014 |
Very good |
| IMD at 10 kHz, % | 0.025 |
Good |
| General performance | Very good |
Frequency response
Left |
Right |
|
| From 20 Hz to 20 kHz, dB | -0.27, +0.02 |
-0.27, +0.02 |
| From 40 Hz to 15 kHz, dB | -0.15, +0.02 |
-0.15, +0.02 |
Noise level
Left |
Right |
|
| RMS power, dB | -109.8 |
-109.8 |
| RMS power (A-weighted), dB | -111.6 |
-111.6 |
| Peak level, dB FS | -77.8 |
-77.8 |
| DC offset, % | -0.0 |
-0.0 |
Dynamic range
Left |
Right |
|
| Dynamic range, dB | +109.9 |
+109.9 |
| Dynamic range (A-weighted), dB | +111.6 |
+111.6 |
| DC offset, % | +0.00 |
-0.00 |
THD + Noise (at -3 dB FS)
Left |
Right |
|
| THD, % | 0.01590 |
0.01590 |
| THD + Noise, % | 0.01593 |
0.01593 |
| THD + Noise (A-weighted), % | 0.02118 |
0.02118 |
Intermodulation distortion
Left |
Right |
|
| IMD + Noise, % | 0.01437 |
0.01437 |
| IMD + Noise (A-weighted), % | 0.01166 |
0.01166 |
IMD (swept tones)
Left |
Right |
|
| IMD + Noise at 5000 Hz, | 0.02968 |
0.02968 |
| IMD + Noise at 10000 Hz, | 0.02255 |
0.02255 |
| IMD + Noise at 15000 Hz, | 0.02370 |
0.02370 |
Maximum power
Calculation formula |
Meaning |
|
| Maximum power, W | (Vrms x Vrms) / 4 Ohm |
230 |
Conclusions
| The LANZAR low-noise transistor amplifier is designed for high-quality reproduction at high power. Due to the
popularity of this circuit, you can find a lot of information on the description, launch and configuration of
this amplifier on the Internet. The characteristics obtained from our laboratory measurements are fully consistent
with measurements in other places and show the high level of this solution.
Summary: The classic, time-tested, symmetrical circuit diagram, bipolar transistor amplifier circuit has won a lot of fans around the world. The simplicity of the circuit and configuration does not require a high level of knowledge in radio electronics. The high output power and quality of the amplifier as a whole make it possible to assemble a powerful and high-quality amplifier that can drive almost any acoustic system. You can buy the module from our kit-amp.com store. |
Related Products
Amplifier MOSFET AUDIOPHILE Premium, 200W
Amplifier module of increased power, high level and Premium quality. The amplifier is designed specifically for "sophisticated" lovers of high-quality audio using field-effect transistors also for aud..
3260.00грн.
Amplifier LANZAR, 100W
The Lanzar amplifier is built according to the classical symmetrical scheme, the preliminary stages of which operate in class A, and the output stage in class AB.The circuit of this amplifier has been..
1460.00грн.
Amplifier LANZAR, 200W
The Lanzar amplifier is built according to the classical symmetrical scheme, the preliminary stages of which operate in class A, and the output stage in class AB.The circuit of this amplifier has been..
2370.00грн.
Related Articles
Amplifier LANZAR 100W, measurements
Testing device Amplifier LANZAR 100W Sampling mode 24-bit, 48 kHz Interface E-MU1616m Testing chain E-MU1616m>Amplifier LANZAR 100W>E-MU1616m Constant..
Measurement technique
Any more or less complex electronic device requires a functional check and adjustmentThe audio power amplifier is no exception and measurements of the characteristics of this device are not only a dev..
Amplifier MOSFET 200W, measurements
Testing device Amplifier MOSFET 200W Sampling mode 24-bit, 48 kHz Interface E-MU1616m Testing chain E-MU1616m>Amplifier MOSFET 200W>E-MU1616m Constant..