Active subwoofer filter, used to cut off the midrange and treble component from the common signal and then connect it to the amplifier. The filter is designed to supply both stereo and mono signal. The operating frequency of the filter is 16Hz-300Hz.
The unit is equipped with the following adjustments:
1. Cutoff frequency
2. Phase adjustment
3. Signal strength
The module with a power supply unit is designed to supply AC voltage 2x 13 ... 25V
In stock transformer for board with power supply

Measurements
Measurement Page
General characteristics
Built-in protection	Yes
Chip	TL072/TL074
Gain	9
Maximum supply voltage (bipolar / constant) DC	35V
Minimum supply voltage (bipolar / constant) DC	17V
Number of channels	mono
Power	Line level
Supply voltage, maximum (alternating / 2 shoulders on) AC	25V
Supply voltage, minimum (alternating / 2 shoulders on) AC	13V

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Enter the code in the box below

Subwoofer filter with PSU

Brands kitON
Product Code: FSPS-01
Availability: In Stock

530.00грн.

Qty

0 reviews / Write a review

Featured Articles

Measurement technique

Any more or less complex electronic device requires a functional check and adjustmentThe audio power amplifier is no exception and measurements of the characteristics of this device are not only a dev..

Subwoofer active filter, measurements

Testing device Active subwoofer filter Sampling mode 24-bit, 48 kHz Interface E-MU1616m Testing chain E-MU1616m>Active subwoofer filter>E-MU1616m Supp..